Page 1 of 1
Dymag fitment-fabricator wanted
Posted: Sun Mar 04, 2012 5:25 pm
Author: Robw
Hi I am after someone who could fit my dymags and Ape calipers to my bike. So they need to be experienced in machining etc. Anyone got any suggestions?
Cheers Rob
Posted: Sun Mar 04, 2012 8:53 pm
Author: neilbarrett
well i was gunna suggest my man ,but as your in suffolk it would be a bit far to travel,nr leeds.i guess every weres a bit of a track from there
Posted: Sun Mar 04, 2012 10:08 pm
Author: Robw
Neil, where is the guy situated because if the guy is good I will travel to him and drop the bike off. You are right though Suffolk is on the edge of the known world
Posted: Mon Mar 05, 2012 11:35 am
Author: CAT3
Rob, if you don't mind travelling you could try Lamb Engineering. I think they are in Wimborne, Dorset. They may be able to help you, or put you in contact with someone nearer to your neck of the woods.
They have built some stunning custom bikes so should be able to do pretty much anything I would guess. Just Google them for their contact details. Someone else that might be able to help & I am sure they are over your way are Krazy Horse Custom Cycles. Their telephone number is 01284-749645.
Posted: Mon Mar 05, 2012 2:02 pm
Author: Mark Stratton
Lamb Engineering are in Salisbury, well just outside.
Here's the link to their website
http://www.lamb-engineering.com/