hi guys,
quick question, when replacing old 2 part head gasket with a new one piece head gasket would one refit the orings under it as well ?
bike is gpz1100 b1 ,
thanks mick
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
fitting comtec head gasket
Moderators: KeithZ1R, chrisu, paul doran, Taffus
fitting comtec head gasket
what,s there to say except we,re all mad on here.
No fill o-ring groove with RTV and let it go off. Trim excess above block surface off then put a light smear onto each side of the gasket instead of the o-ring before fitting.
This way you don't have to get the excess out of the tunnel after fitting.
This way you don't have to get the excess out of the tunnel after fitting.
Rich
diplomacy is a form of art - I was never any good at art
diplomacy is a form of art - I was never any good at art
-
paul doran
- Area Rep.
- Posts: 15910
- Joined: 24th Sep 2004
- Location: near Dublin Ireland
Who is online
Users browsing this forum: No registered users and 18 guests