Page 1 of 1
Taylor Leads - Coil End
Posted: Wed Dec 07, 2011 6:22 pm
Author: njwmct
Could anyone advise the correct method for crimping Taylor Leads at the coil end?
A photo of the correct end result would be great!
Posted: Wed Dec 07, 2011 6:37 pm
Author: Rich
For Dyna coils: Just look at a car lead, you need to do the same sort of thing, I made a crimper by drilling through two bits of steel flat bar, bit of hacksaw work and filing. Then put them in the vice and squeeze up.
I'll send you a photo of it over the weekend.
Original Kawa coil leads are molded in and you won't fit Taylor leads to them easily.
Posted: Wed Dec 07, 2011 6:40 pm
Author: njwmct
Rich wrote:For Dyna coils: Just look at a car lead, you need to do the same sort of thing, I made a crimper by drilling through two bits of steel flat bar, bit of hacksaw work and filing. Then put them in the vice and squeeze up.
I'll send you a photo of it over the weekend.
Original Kawa coil leads are molded in and you won't fit Taylor leads to them easily.
Thanks & yes it's for fitting to Dyna Coils
Posted: Wed Dec 07, 2011 7:05 pm
Author: Pigford
The ends are a bit confusing - but the more solid end with the little hole is fitted to the lead - and the core wire can thread thru' the hole
Best to put the waterproof rubber on first though
