Z1OwnersClub GB

Posted: **Mon Nov 28, 2011 2:23 am**

Lend my service manual and now Iâ€™m working on 26.mm Z1000A carbs.

Donâ€™t remember the float level from gasket to the top of the
float? I if remember last time then I think it was near 28mm, but not sure
or 4.mm from the surface?

Thanks

Posted: **Mon Nov 28, 2011 9:32 am**

3-4 mm I'd say

Posted: **Mon Nov 28, 2011 11:57 am**

My clymer manual says, 1977 = 25mm and 3mm, 1978 = 26mm and 4mm,
always had mine at the 26mm and 4mm setting.

Posted: **Mon Nov 28, 2011 2:16 pm**

[quote="kev edwards"]My clymer manual says, 1977 = 25mm and 3mm, 1978 = 26mm and 4mm,
always had mine at the 26mm and 4mm setting.[/quote

Yes 26.mm = 4.mm it was...,

Thanks for your info and help,

Z1OwnersClub GB

Float level Z1000

Float level Z1000