Z1OwnersClub GB

One Question please.

Do have Boyer + Accel 140403 coils witch needs resistors.
Bike is KZ1000 ´78.

Going to put 1.ohm, 25watt on each coil. Have one RED/Yellow from
ignition switch (power) to the coils witch spits into "Y" to both coils.
One Green connects to RH coil and Black to LH coil.
The Red/Yellow power from switch splits into "Y" both coils.

Question is: Do I set the Resistors on the LH coil Red/Yellow and
the RH coil green wire or the wire witch goes into "Y"

If Ii is RED/Yellow wire then it seems that I have two resistors on the "Y"

Hope you understand this explanation.

Thanks in advance

they have to be connected to the positive feed to the coils if there are two coils you will need two resistors

Thanks I got it z1bman



Thanks for your reply.