RESISTOR

[Hawk1]

One Question please.

Do have Boyer + Accel 140403 coils witch needs resistors.
Bike is KZ1000 ´78.

Going to put 1.ohm, 25watt on each coil. Have one RED/Yellow from
ignition switch (power) to the coils witch spits into "Y" to both coils.
One Green connects to RH coil and Black to LH coil.
The Red/Yellow power from switch splits into "Y" both coils.

Question is: Do I set the Resistors on the LH coil Red/Yellow and
the RH coil green wire or the wire witch goes into "Y"

If Ii is RED/Yellow wire then it seems that I have two resistors on the "Y"

Hope you understand this explanation.

Thanks in advance

[z1bman]

they have to be connected to the positive feed to the coils if there are two coils you will need two resistors

[Hawk1]

Thanks I got it z1bman



Thanks for your reply.