Page 1 of 1
advice about eng case
Posted: Tue Sep 20, 2011 6:45 pm
Author: baz
sorry don't know how to do the link, but can any one tell if these casings are standard or bored out (ebay 320758062979) is the main cap braced, and could they be used in a standard eng rebiuld....cheers lads
Posted: Tue Sep 20, 2011 6:52 pm
Author: Z1parR
Posted: Tue Sep 20, 2011 6:59 pm
Author: Ginger Bear
Posted: Tue Sep 20, 2011 7:05 pm
Author: Pigford
Iop csing doesn't look as its been machined out
Hard tpo be sure.
See what you mean about the crank location cap - looks aftermarket - not a bad thing
Posted: Tue Sep 20, 2011 7:25 pm
Author: hillbilly
naaa there not drilled.
Posted: Tue Sep 20, 2011 8:02 pm
Author: baz
so do you think 900 barrels will fit ok
Posted: Tue Sep 20, 2011 9:30 pm
Author: Ginger Bear
Yup........ No problem.
Posted: Tue Sep 20, 2011 11:45 pm
Author: Garn 1
As Pigford says; "hard to be sure" to see from photo's, if cases have been bored to fit the heavier Z1000 bore. However, the standard bores barrels will always fit, albeit, the useless o-rings at the bottom may not be effective.
The main centre bracket does look modified but it may have just been lost and another made up.
RegardZ.
Posted: Wed Sep 21, 2011 7:12 am
Author: baz
thanks for that lads
Posted: Wed Sep 21, 2011 6:36 pm
Author: Rich
The crank cap has a APE style spreader plate fitted, most likely machined flat under it. Not a bad thing, but I would expect the cases have been bored for bigger sleeves to go with the cap.