Handle Bar dimensions
Posted: Wed Jul 27, 2011 5:59 pm
Just starting to get the bits together for my Z1A .Could any of you guys tell me the width and rise of a set of original Z1 high bars.
Thank's
Thank's
Roger, getting the exact replica's is not easy.
There is usually three or more dimensions to consider.
Dia of tube, width of bars, rise and pull-back.
I think the "rise" on the standard bars for the Z1 and Z1A is 5 inches. I understand the Z1 B did have an option of lower bars.
The rise is critical because of its effect on the length of clutch and throttle cables.
Have a check through the usual Z1 part catalogs/ sites. They may nominate the "standard" bars. Kawasaki does still make them at a co$t....$$$$!
RegardZ.