Z1OwnersClub GB

Posted: **Fri Jul 22, 2011 1:36 pm**

what is the pin diameter in the stock z1000 motor.
thanks in advance..

Posted: **Fri Jul 22, 2011 2:24 pm**

Hi Stubby, it is 16.997mm with a wear limit of 16.96mm in inches it is 0.669" with a wear limit of 0.668".

Posted: **Fri Jul 22, 2011 3:25 pm**

Bloody hell Kev, that's a very comprehensive answer :bow

..... I'd have just said 17mm. :up

Posted: **Fri Jul 22, 2011 7:45 pm**

Ginger Bear wrote:Bloody hell Kev, that's a very comprehensive answer ..... I'd have just said 17mm.

Steve, pitfalls of working in an industry where every micron counts, hopefully it do'nt make me an annorak. :roll:

Posted: **Fri Jul 22, 2011 9:08 pm**

Not at all Kev..... Good to have some spot on accurate advice.

gudgeon pin diameter