Page 1 of 1
Z1 Master Cylinder Rebore to 5/8" ?? Who does it?
Posted: Sun Dec 06, 2009 10:41 pm
Author: DogsbolloxofZ1B
I've searched the forum but can't find the answer
I have an old Z1 master cylinder that needs opening-up tp 5/8", anybody know who does this:?:
Next I need to get the parts annodized and I think Mikey can get this done.
Mike
Posted: Sun Dec 06, 2009 11:05 pm
Author: mikey
Hi mike can do (the anodizing that is)
Posted: Sun Dec 06, 2009 11:31 pm
Author: steve
Mike,
Phil Klusak (Peterborough area) used to rebore master cylinders to 5/8 in. Give me a call in the week, I'll try to dig his number out.
Steve
Posted: Mon Dec 07, 2009 7:40 am
Author: tlc
Mark Hutton did mine.
Mark Hutton(01420 489859 mon-fri)
Re: Z1 Master Cylinder Rebore to 5/8" ?? Who does it?
Posted: Mon Dec 07, 2009 7:41 am
Author: PJ
DogsbolloxofZ1B wrote:I've searched the forum but can't find the answer
I have an old Z1 master cylinder that needs opening-up tp 5/8", anybody know who does this:?:
Next I need to get the parts annodized and I think Mikey can get this done.
Mike
Hi Mike, try Al Marshall
Posted: Mon Dec 07, 2009 8:00 am
Author: GEZ635
I can second that . Al will do a very nice job for you.
Posted: Mon Dec 07, 2009 8:11 am
Author: DogsbolloxofZ1B
Terrific, I've got a few leads now and will make some calls today.
Mike
Posted: Mon Dec 07, 2009 8:25 pm
Author: GUYZED
Mike - like TLC said Mark Hutton is the man to go to, he did mine on my Z1000 - excellent job.