Z1OwnersClub GB

Has anyone with Lester mags swapped the rear bearings, I could do with a little advice to help me remove my old knackered ones. I have done it on my standard wheels but these won't shift even with a bit of heat

Thanks for any help.

hi mate remove balls n inner race the put a run off weld right round inside of outer race this will shrink outer rac n itll drop out steve

steve.w wrote:hi mate remove balls n inner race the put a run off weld right round inside of outer race this will shrink outer rac n itll drop out steve

I can remove the inner race but I would have to pass on the welding

hi mate i can do it for ya but im in co durham steve

steve.w wrote:hi mate i can do it for ya but im in co durham steve

Thanks for the offer, but as you say Durham is a fair trip

Try using a rawl bolt to knock the bearing out. I've done it with ones where you couldn't get enough on the bearing to knock it out. Put rawl bolt in, expand it and then knock the whole lot out.

Rich wrote:Try using a rawl bolt to knock the bearing out. I've done it with ones where you couldn't get enough on the bearing to knock it out. Put rawl bolt in, expand it and then knock the whole lot out.

Thanks, I will have a go at that. Clever idea