Z1OwnersClub GB

Posted: **Fri Sep 11, 2009 5:40 pm**

hi lads, going to fit electronic ignition to my z1a, is it boyer or dyna ? and will they have them at staff show. cheers baz

Posted: **Fri Sep 11, 2009 6:19 pm**

Dyna . Get it from Z1 Enterprises .

fer

Posted: **Fri Sep 11, 2009 7:25 pm**

DYNA - every time :wink:

Posted: **Fri Sep 11, 2009 11:35 pm**

Yep DYNA from me aswell - put it in set it up and forget about it

Posted: **Sat Sep 12, 2009 10:17 am**

cheers lads, dyna it is then. are they easy to fit.

Posted: **Sat Sep 12, 2009 12:17 pm**

Yeh......Dyna is easy as long as your mechanical advance unit is in good nick. Just done mine took about an hour including all the wiring mods I had to do that you won''t have to .

Posted: **Sat Sep 12, 2009 2:54 pm**

Hi BAZ
Should take about 30 mins to fit. very simple and nothing to break down as can happen with other ignitions. Basically all you do is remove the points/condensors/timing plate etc and fit the new ignition plate and plug it into the coils.
Like has been said, i got mine from http://www.z1enterprises.com/
though the dollar pound exchange was a lot better then.

this is what i fitted to my Z1A , MAKE SURE YOU GET THE CORRECT ONE FOR YOUR ADVANCE
http://www.z1enterprises.com/detail.aspx?ID=200

simples

Posted: **Sat Sep 12, 2009 5:27 pm**

cheers for that pal

Posted: **Sat Sep 12, 2009 7:26 pm**

I think Chrisu did a "blow-by-blow" guide (with photo's) on here somewhere :wink: