Two part question for the A1.
Firstly when up to temp and moving from a standing start I need to feather the throttle. If I roll it on it bogs down and kills the motor, just easing it on a little and increase the revs it gets smooth enough to take off. Does this sound like the pilot circuit ? I haven't had the mikunis off yet so don't know the internal setup is and I haven't got any jets to change the setup. Everywhere else in the throttle range it reacts sweet, it has 4 into 1's and pods fitted.
Second question is the PO fitted a manual cam adjuster, I always had the auto ones myself, whats the rule of thumb for how often to adjust and an Idiots Guide to adjusting correctly ??
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Carbie & Cam Chain
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Carbie & Cam Chain
Nico
Try raising needle (lower clip) to bring more fuel in, just on throttle - this effects from "initial throttle-1/4 throttle", depending on needle/needle jet's fitted.
Manual c/c adjuster...... use kickstart and load engine slightly (slackens rear of cam chain). Loosen adjuster lock nut and wind in by hand until resistance is felt; back off 1/2 turn - done
Tighten lock-nut 
Manual c/c adjuster...... use kickstart and load engine slightly (slackens rear of cam chain). Loosen adjuster lock nut and wind in by hand until resistance is felt; back off 1/2 turn - done
Tighten lock-nut And on the 7th day... Zeds were created!
Who is online
Users browsing this forum: No registered users and 18 guests