Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
carbs
Moderators: KeithZ1R, chrisu, paul doran, Taffus
-
trikerrick
- Regular Poster
- Posts: 36
- Joined: 8th Feb 2012
- Location: scunthorpe
carbs
hi chaps,ive recently put a 1170 kit on my kwaka z1100 A3 1985 shafty.it has four straight through pipes on aswell(its a trike)..my question to the panel is,what would be the best carb set up to use??rick...
ride it like ya stole it!!!!
Trickerick, check whether you have vacuum petrol cock and whether it is dual or single feed. Then I would go for Z1R 28mm Mikuni's .... Check that rubber inlet manifold is same as earlier Z1000 models. Also, check if the carbs have accelerator pumps... Ideally, find one without.
Sorry don't know much about '85 models
Regardz.
Sorry don't know much about '85 models
Regardz.
Garn (Sydney) Z1, Z1A, Z1B and Z900-A4
Mikuni RS34 or 36 probably easiest to get & set up - Mikuni VM29or 33 for original pose & performance 
Go for slightly smaller options if want more torque & mid/low performance, or large variants if chasing more top end .... but all will be a major improvement over standard
PS: Avoid CV carbs if you can
Go for slightly smaller options if want more torque & mid/low performance, or large variants if chasing more top end .... but all will be a major improvement over standard
PS: Avoid CV carbs if you can
And on the 7th day... Zeds were created!
-
trikerrick
- Regular Poster
- Posts: 36
- Joined: 8th Feb 2012
- Location: scunthorpe
Who is online
Users browsing this forum: No registered users and 16 guests