Just about to set up my carbs & in particular the float height (VM28SS carbs / Z1000 MKII).
As the carbs are off the bike I'm measuring the actual float height rather than the service fuel level.
A member on the forum was kind enough to give me the float height measurement for these carbs as 26mm +/- 1mm (data from a Clymer manual)
My question is what to use as the datum point on the carb e.g.
1.Carb body outside casting ?
2.Carb body gasket face with gasket removed?
or
3.Carb body gasket face with gasket in place ?
Can ayone tell me which is correct ?
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Float Height Measurement Minuni VM28SS Carbs.
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Who is online
Users browsing this forum: Bing [Bot] and 11 guests