Page 1 of 1
Z1R Fork tubes
Posted: Thu May 07, 2009 9:24 pm
Author: Roger Hill
Any one out there got a good set of Z1R fork inner tubes with good chrome or can recomend a firm that can rechrome my set in the east midlands if poss.The tubes are different to the Z1000 A1 but the same as the A2 the part number is 44013-1003.
Thanks
Posted: Thu May 07, 2009 9:46 pm
Author: Mark Stratton
AM Philpot (Hard Chrome) Ltd -
www.pittedforks.co.uk
I've not personally used these guys but I have heard good reports.
Posted: Thu May 07, 2009 9:59 pm
Author: bedlow1
or try dave marsden zed power, i got a set of repro ones off him for my Z1R about 3 years ago, after a bit of haggling at the time it worked out cheaper than the phil pot route, and I managed to flog my old pitted ones on ebay! .
Posted: Thu May 07, 2009 10:27 pm
Author: mikey
Yep got my A2 fork legs off Zpower cheaper than re working old ones
Posted: Fri May 08, 2009 5:23 am
Author: steve f
i am going to break a complete Z1R sure the forls are ok will have a look tonight
bits
Posted: Fri May 08, 2009 4:22 pm
Author: ted1r
Steve Can I have first dibs on the loom?
Ted
Posted: Fri May 08, 2009 7:19 pm
Author: PJ
steve f wrote:i am going to break a complete Z1R sure the forls are ok will have a look tonight
Steve, is the front wheel 18" or 19" as the prez is after an 18"
Posted: Fri May 08, 2009 7:23 pm
Author: hillbilly
what prise engine
Re: Z1R Fork tubes
Posted: Sat May 09, 2009 9:05 am
Author: Gus
Roger Hill wrote:Any one out there got a good set of Z1R fork inner tubes with good chrome or can recomend a firm that can rechrome my set in the east midlands if poss.The tubes are different to the Z1000 A1 but the same as the A2 the part number is 44013-1003.
Thanks
http://www.discovolantemoto.co.uk/fork- ... at_73.html
Posted: Sat May 09, 2009 12:33 pm
Author: steve f
PJ wrote:steve f wrote:i am going to break a complete Z1R sure the forls are ok will have a look tonight
Steve, is the front wheel 18" or 19" as the prez is after an 18"
its an 18in front wheel got to work out if its better broken or sold complete
will start a new thread