Page 1 of 1
Crankcase breather plates
Posted: Wed Feb 25, 2009 1:30 pm
Author: Big Fluff
Fitted a low profile breather to my turbo bike but all it did was puke oil out so I'm going to refit the original tall breather, only problem was a missing plate inside (with the two curved rubbers in).
Can anybody help me out with the plates please..... that's all I need.
Many thanks, Will
plate
Posted: Wed Feb 25, 2009 2:42 pm
Author: AL MARSHALL
hi Will, pm me your address again and i will send you plate c/w rubbers
regards al
Posted: Wed Feb 25, 2009 7:17 pm
Author: Pigford
I got one an'all.......... PX for the low profile jobby
Posted: Wed Feb 25, 2009 7:27 pm
Author: Big Fluff
Pigford wrote:I got one an'all.......... PX for the low profile jobby
Bugger off Piggy, it's mine
You can have it for nowt though... I'll stick it in the post to your works address ok mate
Posted: Wed Feb 25, 2009 7:55 pm
Author: Pigford
Cheers pal.....
Posted: Wed Feb 25, 2009 8:02 pm
Author: Big Fluff
Big Fluff wrote:Pigford wrote:I got one an'all.......... PX for the low profile jobby
Bugger off Piggy, it's mine
You can have it for nowt though... I'll stick it in the post to your works address ok mate
ON SATURDAY