harris 4 into1

[brian 450]

does any one have a good condtion harris for sale?

[Pigford]

You mean like this one...................


http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0308505947

[paul doran]

the blue chair is free

[kano]

might be worth a bid!

[KWACKERZ1]

Debbens are doing stainless pipes now very similiar to the harris's for zedz so it might be worth checking with them if they do a gpz11 variant, as it may be a better longer term investment than a steel harris.

or check this

http://www.exhaustcraft.co.uk/exhausts.html

[brian 450]

tried to call exhaust craft with no luck phone rings and then hangs up!! dibben not got any in stock

[phil churchett]

tried to call exhaust craft with no luck phone rings and then hangs up!! dibben not got any in stock

Brian, Exhaustcraft posts on here, try a pm or an e-mail, there may be a problem with his phone.

[Taffus]

I am fitting a predator SS exhaust to my GPz, I'll bring it along for you to have a look at if you want
http://www.predatorexhaust.co.uk/unitrader/shop/product/KAWASAKI-Z1100R-1984-6-INC-IMPORTS-4-1-ROAD-EXHAUST-SYSTEM/1017

[KWACKERZ1]

Brian, I was intrigued after posting the link so I emaild exhasut crafte and this was the reply:

Hi We do not have the mandrel bender tooling yet for the 650,as it is £3000 a set,the Z1000 system is £470 inc vat plus £10 delivery,that is fully finished (polished) as made is £390 inc vat.The exhaust comes with a stainless steel bracket for a Z1000 A1,the system will fit a GPZ1100 and a Z1000J
Cheers David Yeowart

Perhaps its worth emailing them!!

[brian 450]

Thanks for info. Is it me or does it hang down a bit low from sump!!!! or is that the same as a harris sits? Phoned norman hyde about there harris and they said they dont make them yet why are they advertising them then? in all the mags and ther web site

[Monk]

Brian

I looked at one of these close up at Debbens, lovely quality but basically sits just the same as a Harris.....bit low.

I got a Harris on mine at the moment, and after much thinking I have come to the conclusion that I am going to use the Harris headers and collector, cut it just under the foot rest and have a nice link pipe and can made up.

[mick znone]

i think the pipe on my old a4 was a harris, it sat low. [pictuers on discussion page], i drove that like a mad man, because i was a mad man. i never had a problem. or am i missing something.

[Monk]

I think this is just about looks Mick.

[Taffus]

Harris is a bit of a pain today, I have been running one on my 1100 and it grinds on some road humps, will hit the curb if you want cross the pavement.
On roads with out humps its not too bad, cornering is ok......

[Padders]

If you fit 17 inch wheels you really do need to check you ground clearance with any of the 4 into 1 exhausts that have two down pipes on top of each other under the engine. Even more essential if you fit USD forks without stepped a stepped top yoke ALA Pigfords bike.