Z1OwnersClub GB

As it says, I would like a set of standard steel engine mounting plates for a Z1000.

I'm presuming A1/A2 are the same as the Ltd.

Also need the spacer for the rear mount as that is shortened to fit the ally plates on my bike.

Ally plates could be up for trade - see Pigford's Z1000 build thread -

http://www.z1ownersclub.co.uk/forum/vie ... c&start=90

I have the front and bottom brackets, I will check if I have the rear ones, from z1000a2. Neil

Thanks Neil, would be interested if you have.

Could you send me your email, cannot remember which ones are the rear, so I'll send you a pic