Z1OwnersClub GB

Morning all,

This is a bit of a long shot, but would anyone happen to have either the spacer or a cush drive that fits between an old Dymag rear wheel and sprocket? It had 5no. 10mm holes on a 90mm pcd, a 75mm bore and is 15mm wide.

Cheers,
Coose

Try TPCS. Steve may have spares.

http://tpcs-magnesium-refurbs.co.uk/

Cheers. I tried Steve and he was extremely helpful in advising that the wheel is from a TZ500 and thus never had a cush drive as the TZ has one in the clutch. It looks like I'll have to get one made as mine is a 5-bolt fixing and a Dymag one (if you can find one) is 6-bolt on a PCD of 100mm...