Page 1 of 1
GPZ1100 Unitrak Seat Lock
Posted: Mon Feb 15, 2016 8:51 pm
Author: RALPHARAMA
Anyone have a seat lock for a GPZ unitrak?
Fingers crossed

Posted: Tue Feb 16, 2016 6:36 am
Author: steve.w
I have 3 but not sure of a key to fit

Posted: Tue Feb 16, 2016 8:07 am
Author: z1bman
key no is stamped on the metal plate at the rear of the lock you may need a magnifying glass to see the no as it is very small it will begin with a z then three no's
Posted: Tue Feb 16, 2016 9:43 am
Author: Roger Hill
Hi Ralph
I should have one as I have about 95% of a GPZ1100A1 rolling chassis I have used the motor from.
Will try and have a look later on as its all in boxes in the back of a shed and I will have to have it all out to find it and it's bloody freezing out there at the moment.
Let me know if you need anything else while I am in there.
Roger
Posted: Tue Feb 16, 2016 10:40 am
Author: RALPHARAMA
Many thanks. The only other thing I guess would be the helmet lock, not that I'd ever use it

, but I s'pose it should be there for completeness
I'm assuming you haven't and immaculate original exhaust system
It's pretty much finished; I wasn't going to bother with the seat lock until I rode it down the road and realised that without it, the seat slides back as you open the throttle

Posted: Tue Feb 16, 2016 12:22 pm
Author: Roger Hill
Just sent you an email with pictures.