Page 1 of 1
GPZ unitrak handlebars
Posted: Sun Oct 25, 2015 2:03 pm
Author: RALPHARAMA
I have just made the joyous discovery that the handlebars on my 1100 unitrak are bent. Rather predictably given the state of the rest of the bike
any one help?
Posted: Sun Oct 25, 2015 3:36 pm
Author: Gus
Hi Ralph.
I may have some you can have but it will take a couple of days for me to check.
Cheers.
Gus
Posted: Sun Oct 25, 2015 5:27 pm
Author: RALPHARAMA
Many thanks Gus
Posted: Sun Oct 25, 2015 7:25 pm
Author: paul doran
I believe I have some if I did not throw them out
I will know in the morning
Posted: Mon Oct 26, 2015 6:01 pm
Author: steve.w
they are meant to be bent near the clamps
Posted: Tue Oct 27, 2015 5:04 pm
Author: Gus
Hi Ralph.
Sorry, looked high and low but no sign of any I thought I had.
I'm sure the lovely Mr. Doran will come to the rescue
Cheers
Gus
Posted: Tue Oct 27, 2015 5:43 pm
Author: RALPHARAMA
Gus wrote:Hi Ralph.
Sorry, looked high and low but no sign of any I thought I had.
I'm sure the lovely Mr. Doran will come to the rescue
Cheers
Gus
Thanks for looking - much appreciated
Posted: Tue Oct 27, 2015 5:48 pm
Author: RALPHARAMA
steve.w wrote:they are meant to be bent near the clamps
The "bend" is where the tube waists to go into the clamp. Are you sure that is correct and not just where some knob has dropped the bike? when I put the waisted section into the 3 jaw chuck on the lathe and turn the chuck it 'wobbles'.
Posted: Tue Oct 27, 2015 5:52 pm
Author: steve.w
vduk wrote:steve.w wrote:they are meant to be bent near the clamps
The "bend" is where the tube waists to go into the clamp. Are you sure that is correct and not just where some knob has dropped the bike? when I put the waisted section into the 3 jaw chuck on the lathe and turn the chuck it 'wobbles'.
yep theres were its meant to be
Posted: Tue Oct 27, 2015 6:25 pm
Author: steve.w
