Page 1 of 1
Z1000 mk2 clutch pusher
Posted: Sun May 17, 2015 12:16 pm
Author: Jerry
Since putting a mark two primary shaft in the Moriwaki, I've learnt, after all these years, that an early clutch pusher and ball bearing won't fit as they are a bigger diameter - has anyone got one under their workbench???
Clutch pusher
Posted: Sun May 17, 2015 6:36 pm
Author: Yellow
Is t
his the One Jerry?
Posted: Sun May 17, 2015 7:36 pm
Author: Jerry
Nope, The other end, that goes inside the clutch basket. Thanks for the reply though.
Posted: Sun May 17, 2015 7:48 pm
Author: Yellow
OK, sorry don't have that bit.
Posted: Sun May 17, 2015 8:29 pm
Author: Z1parR
I'm sure i have a MK11 one Jerry .
44mm head dia , 10mm shaft dia , 9.5mm ball bearing dia .
Posted: Mon May 18, 2015 12:23 pm
Author: Jerry
Thanks For looking, but the 10mm shaft size is the earlier type.
