Z1OwnersClub GB

Ok these are little bits and bobs that are bugging me and whilst not looking like much on their own some of them only come in sets and postage is stupid and ofter more than the cost of the part when a second class postage stamp would cover it.

Has anyone got:

1x Side stand spring GPZ 1100 A1/2 but anything will do - Sorted

2x Z1 oval rear light lens screws

1x carb top screw Z1000 miki's - Sorted

LH and RH switches Z1 / 900 / 1000 with throttle doesn't really matter which model - LH sorted Thanks Redbeard Still RH required.

1x Broken set of clocks as I only want the tops with glass if possible so I can build some other clocks inside them

1x Z1 / 900 / 1000 bottom cam chain guide roller rubber (the bigger thicker one)

1x Manual cam chain tensioner (New APE from the USA £32 and postage £35 ) - Sorted

1x Gear lever with decent splines to cut up for rear sets

Cheers,
Phil.

Hi Phil, you can borrow my LH / RH switches from my Zed until it's
ready for rebuild if that helps? May even buy new pattern one's,
not decided yet. They are in good useable condition.

£39.40

http://www.ebay.co.uk/itm/1973-1975-Kaw ... 3#shpCntId

tail light screws part no 220E0435A available at cradley

tail light screws part no 220E0435A £2.41 each available from cradley

Thanks Jay will let you know mate.

Thank you z1bman.

Cam chain tensioner purchased

pm me your address - carb top screw and side stand spring i can do

Thank you chrisu.

Much appreciated.

If someone can confirm it is the same, I have LH switchgear off a 1977 z750 twin you can have. Fairly certain they share the same switchgear??

Redbeard, this is the L/H switch gear from my kz1000B2 LTD
to see if it matches to your z750 twin L/H switch gear.

cheers Jay, looks the same to me.

Thank you Redbeard

LH switch now sorted but RH with throttle still outstanding if anyone can help?

Cheers,
Phil.