Page 1 of 1
Cibie Headlight Side Light Bulb Holder
Posted: Mon Dec 02, 2013 8:52 pm
Author: PJ
You know what it's like............................
Strip lots of parts off the bike, bulb holder needs soldering - put it safe to repair at a later date.............................
Do you think I can find the bas*ard thing ........................................
No
Anyone got a spare or know where I can get one that will fit??
Cheers
Posted: Mon Dec 02, 2013 9:18 pm
Author: z1bman
Posted: Mon Dec 02, 2013 9:53 pm
Author: PJ
First one may do it, cheers matey, I just need to find the rubber grommet now as well.......................
Doh
Posted: Mon Dec 02, 2013 10:52 pm
Author: KeithZ1R
PJ wrote:First one may do it, cheers matey, I just need to find the rubber grommet now as well.......................
Doh
In th past PJ i have used a small electrical grommet just not sure what size , , ,maplins are good or if you can measure the hole size VWP
Posted: Mon Dec 02, 2013 11:14 pm
Author: PJ
KeithZ1R wrote:PJ wrote:First one may do it, cheers matey, I just need to find the rubber grommet now as well.......................
Doh
In th past PJ i have used a small electrical grommet just not sure what size , , ,maplins are good or if you can measure the hole size VWP
Cheers Matey - Good idea
Posted: Tue Dec 03, 2013 1:03 pm
Author: Big Fluff
I think you need the angled bulb holder grommet though to be 100% but if you're not bothered about that then that's fine.
Posted: Tue Dec 03, 2013 1:23 pm
Author: z1bman
this is the rubber grommet made by Kawasaki that is fitted to various models
http://www.full-throttle-projects.com/i ... ts_id=2691
Posted: Thu Dec 05, 2013 8:12 am
Author: PJ
Thanks Guyz