After a few bits for my bitza
Posted: Fri Jun 07, 2013 12:37 pm
Hi guys firstly thanks for looking .
I am after the following :
Offset front sprocket for 530 pitch 3/8 or 10 mm for a 180 section tyre.
But must be compatable for gpz1100 a3 out put shaft .
Mk1 1200 bandit rear caliper could be complete with carrier I don't mind , if it needs rebuilding I don't mind if its a bit cheaper .
An exhaust with a flat collector for the zed
Again thanks for looking
Lee
I am after the following :
Offset front sprocket for 530 pitch 3/8 or 10 mm for a 180 section tyre.
But must be compatable for gpz1100 a3 out put shaft .
Mk1 1200 bandit rear caliper could be complete with carrier I don't mind , if it needs rebuilding I don't mind if its a bit cheaper .
An exhaust with a flat collector for the zed
Again thanks for looking
Lee