Z1OwnersClub GB

The bike has gone to a mates workshop due to lack of time.
the remit is to basically recommission it and MOT it.
mainly a carb strip and clean, service and MOT.
He has commented that the loom is in a bit of a state, mainly due to previous owners doing what people do, new tape old tape, electronic ignition.
So i though that a new loon would be a good proposition if possible. I asked an auto electrician mate who said try to see if a new one can be bought first before we go down the route of making one from scratch.

So new loom Wanted please.
1980 Z650 B i think.

This guy in the US makes them Baz, his name is Dan http://www.cwswiring.com/

750steve wrote:This guy in the US makes them Baz, his name is Dan http://www.cwswiring.com/

cheers my good man

750steve wrote:This guy in the US makes them Baz, his name is Dan http://www.cwswiring.com/

emailed, but if there is a uk one then that would would easier

There's not mate, unless a NOS one comes up on e'shaftmeuptheass'bay, which it wont!

Might take Dan a bit to get back to ya, he's usually very busy & the loom's are better than original (heavier wire)

750steve wrote:There's not mate, unless a NOS one comes up on e'shaftmeuptheass'bay, which it wont!

Might take Dan a bit to get back to ya, he's usually very busy & the loom's are better than original (heavier wire)

he got back to me, cheers.

Good job Baz..still on TDR?