Page 1 of 1
Offset front sprocket
Posted: Wed Jan 09, 2013 11:37 am
Author: harrythemagnum
Just about to order one, but you never know what members might have spare.
Wanted 5/8" offset, 530 pitch, ta.
Posted: Wed Jan 09, 2013 12:14 pm
Author: Gus
I haven't got one but people will want to know how many teeth and what output shaft fitting.
Cheers
Gus
Posted: Wed Jan 09, 2013 4:20 pm
Author: dixiethedog
evilbay usa.
You find a few in the dragbike spares section. I bought one stateside for just a few quid,much cheaper than some of the ones here.
If you rich try debben or talon.
Sprocket
Posted: Wed Jan 09, 2013 5:07 pm
Author: stempy
Posted: Wed Jan 09, 2013 5:57 pm
Author: steve.w
gsxr 750 fits straight on to gpz1100j b1 2 etc
Posted: Wed Jan 09, 2013 6:35 pm
Author: harrythemagnum
For Z1000A1, back wheel is ZZR1100 (530 sprocket), so Talon it is then.
Posted: Wed Jan 09, 2013 6:50 pm
Author: Gus
What gear ratio are you going for with the zzr rear wheel diameter and the sprocket size?
Steve Debben has done this chart which is very useful.
http://z1ownersclub.co.uk/forum/viewtop ... gear+ratio
Cheers
Gus
Posted: Wed Jan 09, 2013 7:20 pm
Author: Ginger Bear
If you want 17t or 18t Debben will be cheaper..........
http://www.debben.co.uk/acatalog/z1000.html (Scroll down)
Posted: Wed Jan 09, 2013 7:21 pm
Author: 750steve
You want a STD ZX6R or ZX7, some years of those were offset but i think it was 10mm, could be wrong on that, you'd need to check the chain pitch too
Posted: Wed Jan 09, 2013 8:29 pm
Author: Gus
Hi Steve
I'm not sure but I think Talon supply Debben.
Cheers.
Gus
Posted: Wed Jan 09, 2013 8:36 pm
Author: harrythemagnum
Spot on, just what I needed, ta.
I'll match the ZZR rear sprocket to what offset front I can source.
Posted: Wed Jan 09, 2013 8:47 pm
Author: Ginger Bear
Gus wrote:Hi Steve
I'm not sure but I think Talon supply Debben.
Cheers.
Gus
Gus,
They do, but Debben will get a better price on a bulk order. It's probably only worth going direct to Talon if you want a 19t.
Posted: Wed Jan 09, 2013 8:51 pm
Author: Ginger Bear
harrythemagnum wrote:I'll match the ZZR rear sprocket to what offset front I can source.
If you're planning to fit a 180 tyre, you will need a 5/8th offset front sprocket.
Posted: Wed Jan 09, 2013 10:59 pm
Author: harrythemagnum
Ginger Bear wrote:harrythemagnum wrote:I'll match the ZZR rear sprocket to what offset front I can source.
If you're planning to fit a 180 tyre, you will need a 5/8th offset front sprocket.
Ok, noted, ta.
