Page 1 of 1

Fuel tap part needed.

Posted: Sun Apr 29, 2012 4:18 pm
Author: Pasc
Gone and lost the small round brass mesh that sits above the bowl in the Z1b fuel tap. Placed it carefully on the bike lift, blinked and it was gone. If anyone has a spare or knows where to get one I'd much appreciate it. Don't s'pose they come in a fuel tap repair kit do they ?

Posted: Sun Apr 29, 2012 5:44 pm
Author: PJ
Sorry Pasc I don't have the part - just wanted to say Hi


Where have you been?

Did you sell the 750??

cheers

Re: Fuel tap part needed.

Posted: Sun Apr 29, 2012 7:00 pm
Author: Dark Skies
Pasc wrote:Gone and lost the small round brass mesh that sits above the bowl in the Z1b fuel tap. Placed it carefully on the bike lift, blinked and it was gone. If anyone has a spare or knows where to get one I'd much appreciate it. Don't s'pose they come in a fuel tap repair kit do they ?


If it's flat and round could you not use one of those fine mesh gauze filters they put in the bottom of pipes used for wacky-baccy?

http://www.ebay.co.uk/itm/100-x-Standar ... 19d06e1430

Posted: Sun Apr 29, 2012 7:36 pm
Author: Pasc
Dark skies, I know those mesh screens for pipes :wink: but the Kwak one is a lot finer and has a small round hole in it but thanks for the input.

Hi PJ not been on a lot lately as I took redundancy in Sept so the bikes had to take a back seat as well we know they cost money. Add to that spending long hours trawling t'internet looking for work by the time evening came the last thing I wanted to do was open the laptop.
Funny you should mention the Turbo. A chap came and bought it / took it away this morning with a big grin on his boat. Now I can actually move around in the garage I thought I'd get stuck into the Z1b.
Hope you are doing well. Got some catching up to on the site over the next couple of nights with pages and pages of "New posts" :lol:
I might need to have a word with Gerry in the next few days, lost his number when I handed the works mobile back and had run out of time to back up contacts. :oops: Is he still about ?
All the best.

Posted: Sun Apr 29, 2012 7:51 pm
Author: PJ
PM sent

Posted: Sun Apr 29, 2012 7:55 pm
Author: Pasc
Cheers PJ.

Posted: Sun Apr 29, 2012 10:47 pm
Author: C Martin
i have one if still needed

Chris

Posted: Mon Apr 30, 2012 8:10 am
Author: Pasc
PM sent Chris.