Page 1 of 1

valve seat cutter

Posted: Wed Dec 07, 2011 8:15 pm
Author: hillbilly
were could i get some. :??

Posted: Wed Dec 07, 2011 8:27 pm
Author: kev edwards
Ebay normally some on there, but that is one of the few jobs that i have always had done by specialist's

Posted: Wed Dec 07, 2011 8:40 pm
Author: z1bman
sold my full set genuine Kawasaki on e bay 6months ago for £70 to some guy in Australia looking back i should have offered it to club

Posted: Wed Dec 07, 2011 8:42 pm
Author: hillbilly
dam,missed that. :cry:

Posted: Wed Dec 07, 2011 8:45 pm
Author: Keefleaf
P.M. Buzzard.

Posted: Wed Dec 07, 2011 10:27 pm
Author: zed1015
Neway cutters are the ones to go for.
Some sets on evilbay.
Pricey though but worth their weight in gold if they are gonna get used regular.
If it's a one off job then more economical to take it to a good engine shop.
Usually about a tenner a seat.

Posted: Thu Dec 08, 2011 7:15 am
Author: hillbilly
cheers for info lads, :wink: they will be used.

Posted: Thu Dec 08, 2011 7:51 am
Author: kas750
Try Mick Wilson in chorley..01257 267115...about 2 quid per seat..
Or Weir Street engineering in Blackburn.. :wink:

Posted: Thu Dec 08, 2011 5:26 pm
Author: hillbilly
:D

valve seat cutters

Posted: Thu Dec 08, 2011 9:39 pm
Author: buzzard
what size cutters are you after, because you will need a 30 degree, 45 degree and a 60 degree angle cutter for the inlet seats, then the same again for the exhaust seats, I have a set of Neway adjustable cutters, there the bollocks but they aint cheap and they aint for sale. your best bet is to try to get a set of kawasaki seat cutters. BUZZARD

Posted: Fri Dec 09, 2011 7:20 am
Author: hillbilly
cheers buzzard.missed them from months ago,still looking,might have a drive over blackburn this afternoon. :wink: