Z1OwnersClub GB

anyone got detailed pics with measurements,of the front wheel spindle spacers on a z1 900.thought they might be the same,but my front wheel is out of line.onlyfour mill but the twin brake calipers wont go in together.

are the bearing out or in to the shoulders suffered the same problem with a rear wheel drove me insane till i spotted it obvious I know but somtimes wood for trees

bearings are ok,ive even tried a h1500 front spindle,gona afta get the grinder out me thinks. the first one was an a1/2 front axle,but found out that they are wider across the bottom.

check the speedo drive is located properly

now this might be right or it might just be me clutching at straws,but i have the top triple tree off a z1,the bottom triple tree might be an a1/2,are the z1000 yokes wider than a z1.

same thing happened to me a while ago and Taffus has a very good point! It certainly was my problem.

I've got a Z900 A4 bottom yoke if you need it
FOC just cover the postage

thanks jack,i think i will have a measure up first to see if it is my problem,will be in touch.

got it today jack,thanks again,ps,send me your address then i can send you the postage.its only fair.

maybe not to clear,but the ruler was touching both sides of the yolk on one side,and the other end was deffinately out a fair bit.problem solved,cheers jack.