I had a set of 29's on my 900 and had the same issue its running a bit weak where the hole is I adjusted the needle height to add more fuel and hey presto I got it running pretty much spot on. I did get it on a dyno though to get it as good as we could. Hope this helps :up I raised the needle heigh...

Hello, I just fitted a set of new CR29's to my Z900. They were bought set up for a 900 and after playing with idle jets it is starting well and revving out ok. Only problem is when you give it a quick twist of throttle it wants to take off then it stumbles and has a HUGE hesitation. Twisting the thr...

I had kind of settled on the CR29's before i started this post, but just wanted to check before i made the purchase.

I was also going to purchase a Yoshi MJN kit for them.
Is this a worthwhile upgrade for the CR's??

Haven't had it on the dyno yet motor is brand new Chris who built it reckons 125/130 bhp Bought it from Mike p off here in the summer its a 1000sz still have the original motor which had some head work done and was quick so looking forward to the spring to test the new motor :D Shit you have quite ...

Thanks for that Jay.

Sounds like you've had experience with both, so could you please tell me one more thing: Do the Keihin's run the same push/pull throttle cable linkage?

Looking at a new set of Keihin CR carbs for my Z900.

Are 29's best suited to standard bore 900 or would you go something slightly larger?

Thanks.

Wayne1960 wrote:Hi yes got it to run, got some leaks and I think timing issues so trying to sort those.

What was it that finally got it to run???

SOLVED!!! Thanks for everyone's help. The fuses were blowing so instantaneously that I thought something had to be earthing incorrectly. Turns out when I replaced the coils I had inadvertently squashed the brown wire that runs to the horn between the coil and frame upon tightening. I haven't even co...

Thanks mate. After some further investigation I figured I didn't have a good earth to the frame. Now when I bridge the two terminals on relay it starts to turn over. However, my new problem is every time I switch the key to the 'ON' position the fuse between the battery and the wiring harness blows ...

OK, I bench tested the starter motor and it appears be working fine. When I tested the relay without the starter motor installed i'm not getting any power on the other side of the relay. I did some further investigation and realised that when I turn the ignition on and earth my circuit tester, I can...

Ok.
I tested it at the starter motor where there is a bit of bare cable and it was good.
I will go and remove it now.

thanks again.

Thanks for the reply.

My voltmeter has gone on the blink so i've been using a basic circuit tester. When I turn the ignition on it shows power coming out the other side of the relay

Been putting together a Z900 this year and have got to the point were I think its ready to fire up. When I turn on the ignition and hit the starter button nothing happens :( I have tested the starter relay and when I turn the ignition on its getting power. What would be the next thing you would chec...