Hi all
i know its not Z parts but n know a few of you have brits as well

iam looking for a unit 650 triumph engine/ bottom end or any motor spares
so i can build one
thanks for looking
steve

Hi looking for a chain guard for z1b must be in good order

thought i'll ask before i buy a new one

Hi

i've just had the same stuff done J.d. wyatt in thetford
front m/guard, h/lamp brackets, bottom covers
rear brake arm great job £70
got his number at work so pm you in the week
steve

Have you tryed norman hyde i get all my racing lockheed spare from him
01926 832352
good luck steve

Hi the float heights ok 24mm in the clymer manual and circlip is on the 2nd groove down which is what the manual says i borrowed a set off an a4 put them on today best it's ever run but after about 20 miles started missing badly got home took the carbs off had a look inside all seemed ok put the old...

Hi i've got a z1b which has been imported and runs bad low down i have stripped the carbs had them in a ultrasonic tank main,pilot jets and needle are all right with the manual i have to have air screws nearly all the way out for it to run ok new plugs timing ok do'nt know what else to do are the ca...

Hi phil


have you checked your float heights
make sure floats arn't twisted when you measure both sides of the carb
carbs off upside down gasket off 24mm from gasket face to the top of the float.
mine was running rich and this worked for me hope the helps

steve

Thanks a lot guys i'll try that and see how it go's thanks

can any one help me i have a z1b which keeps flooding i have changed float valves and seats i can borrow a tool to measure float height not fuel height but i dont know what it should be ??? thanks steve