Also check inlet rubbers. Look for cracks. Check that they are seated correctly. Check vacuum blanks on all on fully. If they are old and have gone hard take them off and put a thin smear of heat proof sealant on them and put them back on. Do not fully tighten them! Tighten them so they just pinch t...

Probably Al Marshall

If you are unsure spray both sides of the gasket with copper gasket and leave to dry prior to fitting.

I don't think it will without mods.

Check my project out Z1000 A2 engine in GPZ1100 UT frame.

Scroll down about half way Link.

Put the cooler on the other way up and feed the lines over the top of the engine and then down between the carbs thats how I had mine setup on my Harris and thats what I am going to do with my current project

felix wrote:Nice build where did you get your speedo?

I bought one of these off fleebay and modified it to fit in the standard clock housing.

Get central wheels to put a bigger rim on it for you.

GPS speedo sorted :D Before: http://i1274.photobucket.com/albums/y429/zpower-images/Zed-Project/SDC13438_zpsqmcsomnk.jpg After: http://i1274.photobucket.com/albums/y429/zpower-images/Zed-Project/SDC13463_zpsznypflbi.jpg Wiring to sort out... http://i1274.photobucket.com/albums/y429/zpower-images/Zed...

Take it out and check that it's moving freely throughout it's range.

Do you have the pinch bolt done up or not?

There is still a few things to sort out and finalize before the initial base build is complete. Once thats done it's a case of stripping it down again finishing a few bits off polishing / chroming, powder coating and spraying etc... Then the build with new bearings, nuts and bolts throughout etc... ...

Coming on nicely there Phil. Looking at the marks on the seat foam, it looks like you're gonna take another slice off of the pillion section? I hope you do, it will improve the profile of the bike. :up Thanks Steve. Yes the area marked in red is being removed. I have still got some work to do on th...

A quick run through of some of the things I have been up to... Shock needed some tlc but I forgot to take pics of after I had finished. http://i1274.photobucket.com/albums/y429/zpower-images/Zed-Project/SDC13034_zpsj5gspx4z.jpg Switch gear and badges repainted http://i1274.photobucket.com/albums/y42...

Hi Paul, Most Jap bikes are 1 tooth to big on the front (aprox 3 teeth on the back). The way I do it is to setup the gearing so that I am just off the redline in top flat out. I was going a bit quick on a zx12r to get it right but it's apart of the fun right :) For any PC plods on here I was on a cl...

zorded wrote:I may have some 120 or 125's
Shall i look?

AL

I maybe interested let me know how much

Cheers,
Phil.

Found this and took a photo of a photo.My zed i think from around 88-89 http://i1083.photobucket.com/albums/j393/adezed/WP_20151116_11_55_18_Pro_zpsx4plbuvn.jpg I remember that zed :) It was at Avon Raceway a couple of times when I used to go to the rwyb thing that the Hells Angels used to put on i...