750steve wrote:There's not mate, unless a NOS one comes up on e'shaftmeuptheass'bay, which it wont!

Might take Dan a bit to get back to ya, he's usually very busy & the loom's are better than original (heavier wire)

he got back to me, cheers.

750steve wrote:This guy in the US makes them Baz, his name is Dan http://www.cwswiring.com/

emailed, but if there is a uk one then that would would easier

750steve wrote:This guy in the US makes them Baz, his name is Dan http://www.cwswiring.com/

cheers my good man

The bike has gone to a mates workshop due to lack of time. the remit is to basically recommission it and MOT it. mainly a carb strip and clean, service and MOT. He has commented that the loom is in a bit of a state, mainly due to previous owners doing what people do, new tape old tape, electronic ig...

Crofty wrote:http://forums.kz650.info/index.php?topic=2232.0

http://www.oldskoolperformance.com/foru ... &start=154

2 minutes googling found these, there will be loads on other sites

tried to join KZ forum but apparently I'm SPAM, yet I don't even like the stuff!

http://forums.kz650.info/index.php?topic=2232.0 http://www.oldskoolperformance.com/forum/viewtopic.php?f=6&t=82&start=154 2 minutes googling found these, there will be loads on other sites you did well young Luke. However the first link won't let me in as not a member and the second is of a...

what wheel Hubs are you using to get a good spacing for radial brakes?

I've been searching but don't seem to be getting far, but there must be some.

I'm looking for a picture of a Z650 with either a single sided swing arm or a mono shock.

questions being,

Which swing arm?

Pigford wrote:Errrrrm, this is the FOR SALE section

AHHH"!!!!!

Righty ho, My Z650 C3 has finally turned up.

On my list of wants are..............

A kick Starter,

A standard seat complete, that either needs recovering or is ready to go.

A wiring diagrame or Maintenance disc.

A main stand.

Thats it for know I think.

All those holes,

Mice or Cheese?

I was "mis-informed" (not intentional tho') :oops: I do have a Z650 frame + V5 with front ends (a std Z900 & a BANDIT 1200 RWU) with rear end (std Z1000 & BANDIT 600 - 160 section tyre) and tank/tail piece and brakes & down pipes, etc, etc.... :wink: whats the idea of a bandit...

I saw one the other week being towed by an artic tractor unit, using the front wheels on the road, and the back had a hook that went on the trucks 5th wheel.

well funny looking but clever at the same time.

draw it out and where the bolt holes need to be, then get a local machine shop to lazer cut them out off 5mm sheet alloy.

Truely inspirational.

Way to go, I don't have the time, skill patients, money etc to go that far.

mainly due to spending my spare cash on track days.