Cheers z1bman, seen that one, but it has the squared off fins, which I could use, but looking for the rounded off version and he has no tensioner

On standard bore. Cheers Crofty.

PM sent

The CTC seems to be popular with a lot of our customers Jim
http://www.ctc.org.uk/membership/member ... s-families

Hi Pete, don't get too many partrs on bike if your going to place frame over engine. Otherwise you might have to get Stivvy to help lift it in from the side and you don't want him hurting himself! All the best Jim

Doable, but, you may need to fit 650 transmission cover and clutch cover and 650 gearbox if you have used the unitrack engine. Clutch release is on clutch cover where as on 650 it is in the lh side of engine and the clutch pushrod runs thru the middle of the gearbox shaft. Of course you would also n...

I had a Rickman that had Girlings on.

The ex500 has a lh threaded rotor bolt, thinkgpz the same

Good work, will be watching your progress!

Only the decal type AFAIK

https://www.z-power.co.uk/merchantmanag ... ts_id=1286

https://www.z-power.co.uk/merchantmanag ... ts_id=1396

or

http://www.cmsnl.com/kawasaki-1984-a2-z ... ml#results

Took mine off recently and it was not reuseable, boght some gasket paper oil and fuel resistant and made one, two minute job.

Thanks Keith

Sure I read on here somebody applying ceramic or vht paint to the inside of new downpipes to stop chrome discolouration.

Anyone done it or know how ?

Getting close to finishing now. I put oil and plugs in it and was surprised it fired up straight away, even without setting the Dyna S up properly. Have recovered the seat and ordered a V and H exhaust. Need the calipers back from powdercoaters, a few bits from the chromers and platers. A few little...