took starter to bits,
found the connector that leads to the outside was broken,
brushes are good

what else needs checking on the starter motor?

or is there an upgrade that can replace this one?

got the rotor off,
the springs and rollers are there,

starter spins as usual when out of engine,

finger test over ports shows no1 cylinder not much compression

long term project or break it

just fitted a new battery,
but the engine is still slow to turn over,
can see the starter motor moving slightly.

gpz1100 -84

-large bolt to take starter rotor off end of crankshaft,
-rotor assembly as mine is cracked inside,
-starter rollers with springs,
-c shaped holder for holding rotor steady to tighten end nut

hope someone can help
thanks

found there was problems turning the engine over, not spinning quickly and smoothly, took left casing off, what size is the bolt fits to take off the starter clutch rotor on gpz1100 84. just noticed inside the rotor magnets are cracked, can they be fixed or need replacing? how do i refit the rotor o...

any tips on using por 15 fuel tank sealant?

on the clutch sprocket cover on gpz1100
-the clutch cable- is this loosely fitted in the hole and adjusted with the nuts?
-the worm drive- where can i get the ball bearings?

and the question of batteries-
whats best? as the size of the battery tray is huge,
it had a 16la2 in before i think

on gpz1100 with yb16 battery
can a smaller size be used?

what is best?

i am looking for 2 fuel taps with bolt spacing 34mm
i have tried this tap in the photo so anything really

how do i get the starter clutch off the end of the crank?
i have taken the small bolt that holds it on,
just need to get it off so i can check the bits

what type of bearing unit is best used, as have looked on that website

any idea of costs?

and what size should the bolts that pass through be?

can anyone confirm this is the gpz1100 rear shock linkages?

where can i get a replacement with nuts and bolts?
as there is too much play in them

this is fitted to a gpz1100,
i need to id it,
and need to replace the top eye spacer/bearing,
it needs pushed out as its held in with circlips
where can i get a replacement?