i went with the standard 630 setup in the end ,and bonded a runner on the top of the swinger just in case.

pm sent

Thanks ladz. Good info. I did find one guy who had made an aftermarket stand - apparently he sold it for both 1100 and 1200 bikes without realising the frame heights were different :oops: :oops: Seems a bit strange for a bike of that size and style not to have one but there you go. CB 13 has it as ...

some tasty bikes there , ..................but that zrx

hi all, has anyone done a 530 chain conversion on a gpz1100b1 ? i need to replace my worn chain and sprockets soon,currently running standard gearing of 15/41 ,with a metamex under braced swinger and zrx rear shocks which is causing the chain to rub the top of the swinger and comes very close to the...

hope ye have a good day for it ,i can,t make it off to the sunny canaries for a week

cork !

That's for the "inferior" 1200
160/60/17 for the rear on the 1100,
You can get a 180 on but not the best for handling IMHO

Hi guys ,here's a link to a blog of our trip into Tennessee,north Carolina ,Georgia area We,ll post more pics when we get back home. We have done a few thousand miles over here and sorry to say no one zed spotted :( We hired a gtr14 for the trip and its brill .it had only 500 miles on it when we pic...

The a1 had 1 needle bearing each side And the a2 went with 2 either side. As jimmock says I,ll cut the old sleeve To make a 2mm shim and we should Ready for the road. I also found bearing in the sprocket Carrier /hub badly worn,no doubt caused By the extra swing arm play.now replaced With a sealed b...

a mean looking machine ,very tasty

thanks for the ebay link ,that looks ok ,i'll check the measurements of the old one and compare .if it's longer than standard it's just a matter of cutting it to suit. i have spotted a few on ebay usa which are good value. i pulled one out of a z750 l2 swingarm i have and it the same except 2mm shor...

hi guys does anyone know where i could get a new sleeve for the swing arm
on my z1000a1? i got new bearings fitted but they're loose on one end .
thanks knut

Looks finished to me ! Lovely machine .

nice wheels well wear simon